Skip to main content

Network

Use the Network page to view and configure the PoE and ETH ports on your SYNA device. For network topology, hardware connection, and addressing guidance, see Network Topologies.

Opening Network Settings​

  1. Open SYSTEM from the navigation bar.
  2. Select Network.

The page shows the following information for each port:

  • Current IP address and subnet mask
  • Gateway
  • Address mode: DHCP or Static
  • Connection status

Click the pencil icon next to a port to edit its configuration.

Editing a Port​

  1. Click the pencil icon next to the PoE or ETH port.
  2. Set the DHCP switch:
    • When enabled, the port receives its network settings automatically.
    • When disabled, the network fields can be edited.
  3. When DHCP is disabled, enter the IP Address, Subnet Mask, and Gateway. All three fields are required.
  4. Click SAVE to apply the configuration permanently.
warning

Saving incorrect network settings can make SYNA unreachable through the edited port.

Recovering from an Invalid Configuration​

If SYNA is no longer reachable after saving port settings:

  1. Connect a USB-C-to-Ethernet adapter to SYNA's USB-C port.
  2. Connect the adapter to a DHCP-enabled network.
  3. Access COLIGO through the fallback network connection.
  4. Return to SYSTEM → Network and correct the affected port settings.